Introduction
ELIFLON PREC. T30 010P is a medium-low viscosity cure incorporated terpolymer of hexafluoropropene, tetrafluoroethylene and vinylidene fluoride. This grade offers significant processing ease and it is suitable for compression, injection and transfer moulding.
T30 010P provides
- Good mould flow
- Low mould fouling
- Easy mould release
- Low compression set
Application
- Moulded goods, e.g. shaft seals
- Calendered goods
- O-rings, gaskets, seals and profiles
- Extruded cords
Use and processing procedures
ELIFLON PREC. T30 010P can be compounded with internal mixers or two-roll mills using typical fluoroelastomers fillers and the other ingredients.
Safety and Handling
Despite the chemical inertness at ambient temperature, ELIFLON PREC. T30 010P should be handled in such a way to avoid contact with skin and eyes. In case of contact, wash thoroughly with soap and water. Store in a well-ventilated place away from any source of heat. Smoking is strictly forbidden in working and storage areas. In the event of fire, toxic gases are produced. Refer to MSDS for additional information.
For the safe handling of other compound ingredients normally used in fluoroelastomers compounding, please refer to the respective manufacturers.
Description
Product description
Copolymer of hexafluoropropene, tetrafluoroethylene and vinylidene fluoride plus cure chemicals
68,5%
1,82 ± 0,03 g cm-3
Off-white
None
Ethers and ketones
Slabs
30 ± 5 {ML 1+10 @121°C}