Sersar - commercializzazione di polimeri fluorurati Sersar - commercializzazione di polimeri fluorurati

ELIFLON P-C20-001
PRECOMPOUND COPOLIMERO

Introduction

ELIFLON P-C20-001 is a low viscosity cure incorporated copolymer of hexafluoropropene and vinylidene fluoride. This grade offers significant processing ease and it is designed for injection and transfer moulding.

P-C20-001 provides

  • Good mould flow
  • Low mould fouling
  • Easy mould release
  • Low compression set

Application

  • Moulded goods, e.g. shaft seals
  • Calendered goods
  • O-rings, gaskets, seals and profiles
  • Extruded cords

Use and processing procedures

ELIFLON P-C20-001 can be compounded with internal mixers or two-roll mills using typical fluoroelastomers fillers and the other ingredients.

Safety and Handling

Despite the chemical inertness at ambient temperature, ELIFLON P-C20-001 should be handled in such a way to avoid contact with skin and eyes. In case of contact, wash thoroughly with soap and water. Store in a well-ventilated place away from any source of heat. Smoking is strictly forbidden in working and storage areas. In the event of fire, toxic gases are produced. Refer to MSDS for additional information.

For the safe handling of other compound ingredients normally used in fluoroelastomers compounding, please refer to the respective manufacturers.

Description

Product description

Chemical Composition
 
Fluorine content
Density
Color
Odor
Solubility
Storage stability1
Physical form
Mooney Viscosity
Copolymer of hexafluoropropene, and vinylidene fluoride plus cure chemicals
66%
1,82 ± 0,03 g cm-3
Off-white
None
Ethers and ketones
Excellent
Slabs
20 ± 5 {ML 1+10 @121°C}
1)At ambient temperature in a well-ventilated place
Chemical Composition
Copolymer of hexafluoropropene, and vinylidene fluoride plus cure chemicals
Fluorine content
66%
Density
1,82 ± 0,03 g cm-3
Color
Off-white
Odor
None
Solubility
Ethers and ketones
Storage stability1
- 9 ± 1°C
Solubility
Excellent
Physical form
Slabs
Mooney Viscosity
20 ± 5 {ML 1+10 @121°C}
1)At ambient temperature in a well-ventilated place
DO YOU NEED TECHNICAL OR COMMERCIAL SUPPORT?
WRITE US HERE.

Logo Sersar

© 2019 Sersar s.r.l.

Registered Office: Via Vittoria, 1 - 40068 San Lazzaro di Savena (BO) - Italy
Administrative and Operational Headquarters: Via Vittoria, 1 - 40068 San Lazzaro di Savena (BO) - Italy

Telephone: + 39.051.625.5442 | E-mail: info@sersar.net | Fax: + 39.051.625.5442
N.REA BO - 482936 - VAT N. 02987671209 | CAP.SOC. € 250.000 I.V.